DJI E-Port V2 Development Kit (CP.EN.00000644.01)

This development kit converts the aircraft’s E-Port V2 into several standard hardware interfaces and includes an onboard microcontroller unit (MCU), making it simple for developers to connect devices and work on SDK development and debugging tasks.

Important Information:

• When integrating the adapter board into a finished payload, it is recommended to include a heat sink and a metal enclosure.

• If you notice sparks, smoke, a burning smell, or any unusual behavior after powering on, immediately turn off the power.

• When using all three XT30 power output ports at the same time, the combined output must stay below the aircraft’s maximum single-port output. Always ensure that payloads are developed within the specified output limits.

Package Contents:

• DJI E-Port V2 Development Board (1 piece)

• DJI E-Port V2 Coaxial Cable (1 piece)

• XT30 to DC5.5 Power Cable (1 piece)

• XT30 to USB-C Power Cable (1 piece)

• SKYPORT V3 Coaxial Cable (1 piece)

• SKYPORT V3 Coaxial Cable Connector Terminal (2 pieces)

• SKYPORT V3 Adapter (1 piece)

• X-Port Adapter Board (1 piece)

• X-Port Electronic Cable (1 piece)

Specifications:

• Development board size: 89 × 60 × 13.4 mm

• XT30 VCC Output: 13.8 V, 17.02 V, or 24 V at 5 A

• XT30 12V Output: 12 V at 4 A

• XT30 5V Output: 5 V at 4 A

Compatibility:

• Designed for use with DJI Matrice 400