Nightforce CFS Spotting Scope Accessory Cage (A733)

The Spotting Scope Accessory Cage is made for the Configurable Field Spotting Scope (CFS) 6-36x50mm F1. This cage gives you five M-LOK® mounting points and 1/4-20 threaded holes, allowing you to attach a range of popular accessories for competitive, recreational, or professional use.

Installation

To install the accessory cage, first remove the lens cap from the eyepiece. Slide the cage over the eyepiece, making sure the horseshoe-shaped opening is facing forward toward the objective lens. The cage should fit between the spotting scope’s body tube and the integrated base.

On the underside, align the six holes of the cage with the corresponding holes in the integrated base. Start by lightly securing a screw on each side to hold the cage in place. Then, insert screws into the remaining holes and tighten them so they are flush with the base, but do not fully torque them yet. Once all screws are in place, gradually tighten them in sequence to 35 in-lb. If a torque driver is not available, use the provided hex wrench and tighten each screw 1/8 turn past the point of initial resistance.